Strong Optical Coupling of Lattice Resonances in a Top-down Fabricated Hybrid Metal-Dielectric Al/Si/Ge Metasurface.

Optical metasurfaces enable the manipulation of the light-matter interaction in ultrathin layers. Compared with their metal or dielectric counterparts, hybrid metasurfaces resulting from the combination of dielectric and metallic nanostructures can offer increased possibilities for interactions between modes present in the system. Here, we investigate the interaction between lattice resonances in a hybrid metal-dielectric metasurface obtained from a single-step nanofabrication process. Finite-difference time domain simulations show the avoided crossing of the modes appearing in the wavelength-dependent absorptance inside the Ge upon variations in a selected geometry parameter as evidence for strong optical coupling. We find good agreement between the measured and simulated absorptance and reflectance spectra. Our metasurface design can be easily incorporated into a top-down optoelectronic device fabrication process with possible applications ranging from on-chip spectroscopy to sensing.

Strongly enhanced sensitivities of CMOS compatible plasmonic titanium nitride nanohole arrays for refractive index sensing under oblique incidence.

Titanium nitride (TiN) is a complementary metal-oxide-semiconductor (CMOS) compatible material with large potential for the fabrication of plasmonic structures suited for device integration. However, the comparatively large optical losses can be detrimental for application. This work reports a CMOS compatible TiN nanohole array (NHA) on top of a multilayer stack for potential use in integrated refractive index sensing with high sensitivities at wavelengths between 800 and 1500 nm. The stack, consisting of the TiN NHA on a silicon dioxide (SiO2) layer with Si as substrate (TiN NHA/SiO2/Si), is prepared using an industrial CMOS compatible process. The TiN NHA/SiO2/Si shows Fano resonances in reflectance spectra under oblique excitation, which are well reproduced by simulation using both finite difference time domain (FDTD) and rigorous coupled-wave analysis (RCWA) methods. The sensitivities derived from spectroscopic characterizations increase with the increasing incident angle and match well with the simulated sensitivities. Our systematic simulation-based investigation of the sensitivity of the TiN NHA/SiO2/Si stack under varied conditions reveals that very large sensitivities up to 2305 nm per refractive index unit (nm RIU-1) are predicted when the refractive index of superstrate is similar to that of the SiO2 layer. We analyze in detail how the interplay between plasmonic and photonic resonances such as surface plasmon polaritons (SPPs), localized surface plasmon resonances (LSPRs), Rayleigh Anomalies (RAs), and photonic microcavity modes (Fabry-Pérot resonances) contributes to this result. This work not only reveals the tunability of TiN nanostructures for plasmonic applications but also paves the way to explore efficient devices for sensing in broad conditions.

Rigorous coupled-wave analysis of a multi-layered plasmonic integrated refractive index sensor.

We apply the rigorous coupled-wave analysis (RCWA) to the design of a multi-layer plasmonic refractive index sensor based on metallic nanohole arrays integrated with a Ge-on-Si photodetector. RCWA simulations benefit from modularity, frequency-domain computation, and a relatively simple computational setup. These features make the application of RCWA particularly interesting in the case of the simulation and optimization of multi-layered devices in conjunction with plasmonic nanostructures, where other methods can be computationally too expensive for multi-parameter optimization. Our application example serves as a demonstration that RCWA can be utilized as a low-cost, efficient method for device engineering.

Photonic-plasmonic mode coupling in nanopillar Ge-on-Si PIN photodiodes.

Incorporating group IV photonic nanostructures within active top-illuminated photonic devices often requires light-transmissive contact schemes. In this context, plasmonic nanoapertures in metallic films can not only be realized using CMOS compatible metals and processes, they can also serve to influence the wavelength-dependent device responsivities. Here, we investigate crescent-shaped nanoapertures in close proximity to Ge-on-Si PIN nanopillar photodetectors both in simulation and experiment. In our geometries, the absorption within the devices is mainly shaped by the absorption characteristics of the vertical semiconductor nanopillar structures (leaky waveguide modes). The plasmonic resonances can be used to influence how incident light couples into the leaky modes within the nanopillars. Our results can serve as a starting point to selectively tune our device geometries for applications in spectroscopy or refractive index sensing.